Arctic Tern Roof Hatch
READ BEFORE ORDERING
Considerations for Fitment

The Arctic Tern Roof Hatch is a wonderful addition to your camper or van. It is available in electric drive only and features a German made Bosch drive motor, and a removable emergency hand crank. These hatches have been tested to 5000 cycles with no failure.
The Roof Hatch features a breathable seal that prevents the entry of dust, but allows for some breath-ability in the cabin. The dome is smoked double pane acrylic. Like all Arctic Tern window panels, these are European made and meet strict ECE/DOT standards for UV resistance and impact. It features a pleated retractable screen and blind. The body of this hatch is high strength ABS. Bright white LEDs can serve as primary light in most cabins. Mounting is by adhesive and clips. This hatch requires 12V service. The interior trim extends down 30mm/1.18". Beginning in November the roof hatch trim will be white.
An optional Spoiler is available. This unique spoiler has a white acrylic exterior laminated to a fiberglass interior layer. The result is a beautiful smooth finish with exceptional strength. Mounting is by 3M high strength tape and screws. This spoiler is highly recommended if the front of the hatch is exposed to high speed oncoming air / water. If the hatch is mounted behind a solar panel or other wind break, it would not be necessary. The spoiler reduces cabin wind noise.
Notes:
-
Standard roof thicknesses from 30mm - 70mm /1.18" - 2.75".
-
Expansion Ring available for roof thicknesses from 70-84mm/ 2.75" - 3.30". $75
-
Sits above the roof about 5"
-
Sits below ceiling a little over 1"
-
Does not have a fan
-
1 Tube of Bostik is recommended for installation. Can also use Sikaflex252 or similar. One full tube is required.
-
Must specify roof thickness when ordering for correct hardware. Options are 30-70mm or 70-84mm.